WARNING: There is NO infinite loop detection right now! So MAKE SURE if you create ANY path from a "StateChanged" to a "ChangeState" node, that you MUSTĮnsure the loop is not permanent or you will burn up cpu! A good enhancement would be perhaps to build in a "keepalive" countdown for 2 iterations or something toĪuto-kill a message stuck in a loop if anyone wants to take that on. The current state will be in and follows the HomeKit Alarm state conventions (same document as above). This node emits a message when the alarm system changes state, such as switching from "Home" to "Away" or "Disarm", or if a sensor triggers an alarm when armed. This was introduced to work directly with Dashboard and a few other node-red nodes.
0 Comments
Leave a Reply. |